Incinolet Canada
Siège et couvercle de rechange pour Incinolet ; SEA00l
Siège et couvercle de rechange pour Incinolet ; SEA00l
Incinolet Toilet Questions
Incinolet Toilet Questions
What power does the Incinolet need?
A dedicated 20 amp circuit. Choose 120 V at about 2000 W or 240 V at about 3500 W.
How many people can it support full time?
120 V model is about 4 people, 240 V model is about 6 people.
Does it use water or need a septic system?
No. It incinerates waste using electric heat and vents outside.
Do I need a bowl liner every time?
Yes, for every use. New units include one box of 200 liners. Bowl Liners can be purchased here.
How long is a cycle and can I use it during the cycle?
Heater runs about 60 to 75 minutes, the blower continues 20 to 40 minutes to cool. You can use it any time during a cycle, then press Start again.
How much electricity per cycle?
About 1.5 to 2.0 kWh per full cycle. Example at $0.20 per kWh is roughly $0.30 to $0.40 per cycle.
What can go in the toilet?
Human waste, toilet paper, and tampons. Do not burn trash or food. Use a liner each time.
How do I vent it?
Horizontal or vertical to outdoors, end with a dryer flap or rain cap. If total run is over 10 feet or uses more than two elbows, increase to 6 inch pipe, 15 feet max. Do not vent into an attic or crawl space.
Will there be odours?
Little to none with correct venting and by starting a cycle after each use. Overloading or poor venting can cause odor.
What happens during a power outage?
If a cycle stops mid-burn you may notice smoke or odour. Open a window. When power returns the fan restarts to cool the unit.
How often do I empty the ash and how do I dispose of it?
Empty when ash is light in color or no more than 2 inches deep. Dispose of cooled ash in household trash per local rules. Do not use it as fertilizer.
Can I run it from solar or a generator?
Technically yes, but we don't advise it. If your system supplies the continuous wattage on a dedicated 20 A circuit. Plan around 1.5 to 2.0 kWh per cycle.
Where can I install it and what clearances are needed?
Cabins, basements, bunkies, boats, RVs, and more. Allow room on the right side to operate the pedal and follow the manual’s clearance notes.
What is the warranty?
3 years on toilets having regular use and maintenance.
Do you offer pickup?
Pickup is available from our Beamsville showroom or our warehouse terminal, stock dependent.
Is Incinolet approved in my area?
Although CSA approved, requirements vary by province and municipality. Treat it as an electrical appliance install and check with your local Authority Having Jurisdiction and a licensed electrician. diction and a licensed electrician.
Shipping and delivery
Shipping and delivery
Every Incinolet toilet includes free shipping anywhere in Canada except Yukon, Northwest Territories, and Nunavut, for a flat shipping fee of $250.00.
Delivery Times
- 2–5 business days
- 2–7 business days
Parts & Accessories
Replacement parts and bowl liners ship via UPS and are subject to standard shipping fees.
Remote or Limited Addresses
If your shipping address is not accessible, please arrange delivery to the nearest post office, courier pickup point, or freight terminal.
Please note: we cannot ship to PO Boxes.
Purchase Orders
Purchase orders are accepted. Include your PO number in the order notes when checking out, and a PDF invoice will be provided after purchase.
Additional Information
Shipments should be inspected on arrival. Please notify us within 48 hours of any damage.
For freight deliveries, carriers may contact you to arrange a delivery time.
Weather and regional conditions can extend transit times, we recommend ordering early if you have a deadline.
Impossible de charger la disponibilité du service de retrait
Retrouvez un confort optimal et assurez une bonne mise en place des sacs grâce à cet ensemble abattant et couvercle de rechange. Conçu pour les toilettes à incinération Incinolet, il s'installe directement et se remplace facilement lorsque l'abattant d'origine est usé. Pour faciliter l'entretien, le manuel indique que la partie supérieure (abattant, couvercle et cuvette) se retire après avoir dévissé quatre vis et retiré le cache en caoutchouc du bouton marche/arrêt.
Caractéristiques principales
Ensemble complet siège et couvercle, remplacement facile grâce aux points de charnière existants.
Permet une utilisation propre des doublures et contribue à maintenir un faible niveau d'odeurs lorsqu'il est installé et fermé correctement.
Conception robuste pour un usage quotidien ; référence de pièce d'origine SEA001.
Compatibilité
Convient aux appareils Incinolet utilisant l'ensemble siège et couvercle standard ; non spécifique à la tension ou au numéro de série.
Ce qui est inclus
1 × Ensemble siège et couvercle ; Réf. SEA001.
Installation et entretien, conseils rapides
Débranchez l'appareil avant toute intervention.
Ouvrez le couvercle, retirez les fixations de la charnière, installez le nouveau siège et le couvercle, et vérifiez que la fermeture sur la doublure est bien en place.
Pour une intervention plus approfondie, le dessus peut être soulevé après avoir retiré quatre vis et le soufflet en caoutchouc recouvrant le bouton de démarrage ; réinstallez le soufflet lors du remontage.
Spécifications
Référence : SEA001.
Poids approximatif : 6 lb ; dimensions : 18 × 15 × 3 po.
FAQ
Est-ce que cela conviendra à mon modèle ?
Oui, il s'agit de l'ensemble siège et couvercle standard Incinolet ; la correspondance se fait par le nom de la pièce et le style de charnière, la tension n'est pas applicable.
Le matériel est-il inclus ?
Utilisez les points de fixation existants pour vos charnières ; suivez les instructions de montage de votre appareil. Si vos charnières sont endommagées, consultez le catalogue de pièces détachées pour les remplacer.
Des astuces pour réduire les odeurs pendant l'utilisation ?
Avant de fermer le couvercle, veillez à ce que les bords du sac soient sous celui-ci et videz régulièrement le bac à cendres comme indiqué dans le manuel.
Partager
