Incinolet Canada
Thermostat de remplacement Incinolet TS Spades, L300 ; THE012
Thermostat de remplacement Incinolet TS Spades, L300 ; THE012
Incinolet Toilet Questions
Incinolet Toilet Questions
What power does the Incinolet need?
A dedicated 20 amp circuit. Choose 120 V at about 2000 W or 240 V at about 3500 W.
How many people can it support full time?
120 V model is about 4 people, 240 V model is about 6 people.
Does it use water or need a septic system?
No. It incinerates waste using electric heat and vents outside.
Do I need a bowl liner every time?
Yes, for every use. New units include one box of 200 liners. Bowl Liners can be purchased here.
How long is a cycle and can I use it during the cycle?
Heater runs about 60 to 75 minutes, the blower continues 20 to 40 minutes to cool. You can use it any time during a cycle, then press Start again.
How much electricity per cycle?
About 1.5 to 2.0 kWh per full cycle. Example at $0.20 per kWh is roughly $0.30 to $0.40 per cycle.
What can go in the toilet?
Human waste, toilet paper, and tampons. Do not burn trash or food. Use a liner each time.
How do I vent it?
Horizontal or vertical to outdoors, end with a dryer flap or rain cap. If total run is over 10 feet or uses more than two elbows, increase to 6 inch pipe, 15 feet max. Do not vent into an attic or crawl space.
Will there be odours?
Little to none with correct venting and by starting a cycle after each use. Overloading or poor venting can cause odor.
What happens during a power outage?
If a cycle stops mid-burn you may notice smoke or odour. Open a window. When power returns the fan restarts to cool the unit.
How often do I empty the ash and how do I dispose of it?
Empty when ash is light in color or no more than 2 inches deep. Dispose of cooled ash in household trash per local rules. Do not use it as fertilizer.
Can I run it from solar or a generator?
Technically yes, but we don't advise it. If your system supplies the continuous wattage on a dedicated 20 A circuit. Plan around 1.5 to 2.0 kWh per cycle.
Where can I install it and what clearances are needed?
Cabins, basements, bunkies, boats, RVs, and more. Allow room on the right side to operate the pedal and follow the manual’s clearance notes.
What is the warranty?
3 years on toilets having regular use and maintenance.
Do you offer pickup?
Pickup is available from our Beamsville showroom or our warehouse terminal, stock dependent.
Is Incinolet approved in my area?
Although CSA approved, requirements vary by province and municipality. Treat it as an electrical appliance install and check with your local Authority Having Jurisdiction and a licensed electrician. diction and a licensed electrician.
Shipping and delivery
Shipping and delivery
Every Incinolet toilet includes free shipping anywhere in Canada except Yukon, Northwest Territories, and Nunavut, for a flat shipping fee of $250.00.
Delivery Times
- 2–5 business days
- 2–7 business days
Parts & Accessories
Replacement parts and bowl liners ship via UPS and are subject to standard shipping fees.
Remote or Limited Addresses
If your shipping address is not accessible, please arrange delivery to the nearest post office, courier pickup point, or freight terminal.
Please note: we cannot ship to PO Boxes.
Purchase Orders
Purchase orders are accepted. Include your PO number in the order notes when checking out, and a PDF invoice will be provided after purchase.
Additional Information
Shipments should be inspected on arrival. Please notify us within 48 hours of any damage.
For freight deliveries, carriers may contact you to arrange a delivery time.
Weather and regional conditions can extend transit times, we recommend ordering early if you have a deadline.
Impossible de charger la disponibilité du service de retrait
Rétablissez la protection contre la surchauffe et des performances constantes grâce à ce thermostat TS Spades, L300. Ce thermostat limiteur TS coupe l'alimentation du chauffage lorsque la température de la paroi de la chambre atteint environ 150 °C (300 °F), protégeant ainsi les composants et garantissant un fonctionnement sûr. Il est monté sous le thermostat du ventilateur et les bornes du chauffage, et accessible par le panneau d'accès latéral droit ; vérifiez visuellement la compatibilité de la pièce et du câblage avant de commander.
Caractéristiques principales
Coupe la puissance de chauffage à environ 300 °F, contribuant ainsi à prévenir la surchauffe et à assurer un fonctionnement plus propre et à faible odeur.
Version TS « Spades » avec bornes à fourche ; se connecte aux fils du circuit de chauffage orange comme spécifié sur la page produit.
Pièce de rechange d'origine pour les unités Incinolet, accès facile via le panneau d'accès latéral droit pour un remplacement rapide.
Complément idéal du thermostat de soufflerie ITS et du thermostat de sécurité STS pour une protection multicouche.
Compatibilité
Utilisé sur toutes les configurations Incinolet ; à sélectionner par nom de pièce et type de borne plutôt que par tension ou numéro de série. Emplacement : sous le thermostat ITS, près des bornes de chauffage, derrière le panneau d’accès latéral.
Ce qui est inclus
1 × Thermostat, TS Spades, L300; SKU THE012.
Installation et entretien (Conseils rapides)
Débranchez l'appareil avant toute intervention.
Retirez le panneau d'accès droit ; notez le cheminement des câbles, puis déplacez les fils chauffants orange de l'ancien TS vers le nouveau TS et fixez-les. Remontez le tout et effectuez un cycle de test.
Inspectez le câblage adjacent et les bornes de chauffage depuis la zone d'accès ; resserrez les connexions desserrées si nécessaire.
Spécifications
Type : Thermostat de limite, TS Spades, point de consigne L300 ~300°F.
Référence : THE012.
FAQ
À quoi sert le thermostat TS ?
Il limite la température de l'élément chauffant en ouvrant le circuit aux alentours de 300°F afin d'éviter toute surchauffe.
Où se connectent les fils ?
Cette version TS « Spades » se fixe aux fils du circuit de chauffage orange ; vérifiez le type de borne et le câblage avant l’installation.
Cette pièce est-elle spécifique à une tension ?
Non, choisissez en fonction du nom et de l'emplacement de la pièce plutôt que de la tension ou de la plage de numéros de série.
Partager
