Incinolet Canada
Incinolet Replacemen Seat & Lid; SEA00l
Incinolet Replacemen Seat & Lid; SEA00l
Incinolet Toilet Questions
Incinolet Toilet Questions
What power does the Incinolet need?
A dedicated 20 amp circuit. Choose 120 V at about 2000 W or 240 V at about 3500 W.
How many people can it support full time?
120 V model is about 4 people, 240 V model is about 6 people.
Does it use water or need a septic system?
No. It incinerates waste using electric heat and vents outside.
Do I need a bowl liner every time?
Yes, for every use. New units include one box of 200 liners. Bowl Liners can be purchased here.
How long is a cycle and can I use it during the cycle?
Heater runs about 60 to 75 minutes, the blower continues 20 to 40 minutes to cool. You can use it any time during a cycle, then press Start again.
How much electricity per cycle?
About 1.5 to 2.0 kWh per full cycle. Example at $0.20 per kWh is roughly $0.30 to $0.40 per cycle.
What can go in the toilet?
Human waste, toilet paper, and tampons. Do not burn trash or food. Use a liner each time.
How do I vent it?
Horizontal or vertical to outdoors, end with a dryer flap or rain cap. If total run is over 10 feet or uses more than two elbows, increase to 6 inch pipe, 15 feet max. Do not vent into an attic or crawl space.
Will there be odours?
Little to none with correct venting and by starting a cycle after each use. Overloading or poor venting can cause odor.
What happens during a power outage?
If a cycle stops mid-burn you may notice smoke or odour. Open a window. When power returns the fan restarts to cool the unit.
How often do I empty the ash and how do I dispose of it?
Empty when ash is light in color or no more than 2 inches deep. Dispose of cooled ash in household trash per local rules. Do not use it as fertilizer.
Can I run it from solar or a generator?
Technically yes, but we don't advise it. If your system supplies the continuous wattage on a dedicated 20 A circuit. Plan around 1.5 to 2.0 kWh per cycle.
Where can I install it and what clearances are needed?
Cabins, basements, bunkies, boats, RVs, and more. Allow room on the right side to operate the pedal and follow the manual’s clearance notes.
What is the warranty?
3 years on toilets having regular use and maintenance.
Do you offer pickup?
Pickup is available from our Beamsville showroom or our warehouse terminal, stock dependent.
Is Incinolet approved in my area?
Although CSA approved, requirements vary by province and municipality. Treat it as an electrical appliance install and check with your local Authority Having Jurisdiction and a licensed electrician. diction and a licensed electrician.
Shipping and delivery
Shipping and delivery
Every Incinolet toilet includes free shipping anywhere in Canada except Yukon, Northwest Territories, and Nunavut, for a flat shipping fee of $250.00.
Delivery Times
- 2–5 business days
- 2–7 business days
Parts & Accessories
Replacement parts and bowl liners ship via UPS and are subject to standard shipping fees.
Remote or Limited Addresses
If your shipping address is not accessible, please arrange delivery to the nearest post office, courier pickup point, or freight terminal.
Please note: we cannot ship to PO Boxes.
Purchase Orders
Purchase orders are accepted. Include your PO number in the order notes when checking out, and a PDF invoice will be provided after purchase.
Additional Information
Shipments should be inspected on arrival. Please notify us within 48 hours of any damage.
For freight deliveries, carriers may contact you to arrange a delivery time.
Weather and regional conditions can extend transit times, we recommend ordering early if you have a deadline.
Couldn't load pickup availability
Refresh comfort and keep liners seated correctly with this replacement seat and lid set. It’s a direct-fit assembly for Incinolet incinerating toilets, designed for quick swap-out when the original seat shows wear. For service access, the manual notes the top assembly (seat, lid, bowl halves) lifts off after removing four screws and the rubber start-switch boot.
Key Features
Complete seat and lid set, easy replacement using the existing hinge points.
Supports tidy liner use and helps maintain low odour when installed and closed properly.
Durable build for daily use; OEM part listing SEA001.
Compatibility
Fits Incinolet units that use the standard seat and lid assembly; not voltage or serial specific.
What’s Included
1 × Seat and Lid set; SKU SEA001.
Installation & Care, Quick Tips
Unplug the unit before any service.
Open the lid, remove the hinge fasteners, attach the new seat and lid, confirm smooth closing over the liner.
For deeper service, the top can be lifted after removing four screws and the rubber boot over the start button; reinstall the boot on reassembly.
Specs
SKU: SEA001.
Approx. weight: 6 lb; dimensions: 18 × 15 × 3 in.
FAQs
Will this fit my model?
Yes, it’s the standard Incinolet seat and lid set; match by part name and hinge style, voltage is not applicable.
Is hardware included?
Use your existing hinge mounting points; follow your unit’s hardware setup. If your hinges are damaged, consult the parts catalogue for replacements.
Any tips to reduce odour during use?
Keep liner edges below the lid before closing and empty the ashpan regularly as recommended in the manual.
Share
