Incinolet Canada
Incinolet Replacement Relay, Omron; REL008/REL007
Incinolet Replacement Relay, Omron; REL008/REL007
Incinolet Toilet Questions
Incinolet Toilet Questions
What power does the Incinolet need?
A dedicated 20 amp circuit. Choose 120 V at about 2000 W or 240 V at about 3500 W.
How many people can it support full time?
120 V model is about 4 people, 240 V model is about 6 people.
Does it use water or need a septic system?
No. It incinerates waste using electric heat and vents outside.
Do I need a bowl liner every time?
Yes, for every use. New units include one box of 200 liners. Bowl Liners can be purchased here.
How long is a cycle and can I use it during the cycle?
Heater runs about 60 to 75 minutes, the blower continues 20 to 40 minutes to cool. You can use it any time during a cycle, then press Start again.
How much electricity per cycle?
About 1.5 to 2.0 kWh per full cycle. Example at $0.20 per kWh is roughly $0.30 to $0.40 per cycle.
What can go in the toilet?
Human waste, toilet paper, and tampons. Do not burn trash or food. Use a liner each time.
How do I vent it?
Horizontal or vertical to outdoors, end with a dryer flap or rain cap. If total run is over 10 feet or uses more than two elbows, increase to 6 inch pipe, 15 feet max. Do not vent into an attic or crawl space.
Will there be odours?
Little to none with correct venting and by starting a cycle after each use. Overloading or poor venting can cause odor.
What happens during a power outage?
If a cycle stops mid-burn you may notice smoke or odour. Open a window. When power returns the fan restarts to cool the unit.
How often do I empty the ash and how do I dispose of it?
Empty when ash is light in color or no more than 2 inches deep. Dispose of cooled ash in household trash per local rules. Do not use it as fertilizer.
Can I run it from solar or a generator?
Technically yes, but we don't advise it. If your system supplies the continuous wattage on a dedicated 20 A circuit. Plan around 1.5 to 2.0 kWh per cycle.
Where can I install it and what clearances are needed?
Cabins, basements, bunkies, boats, RVs, and more. Allow room on the right side to operate the pedal and follow the manual’s clearance notes.
What is the warranty?
3 years on toilets having regular use and maintenance.
Do you offer pickup?
Pickup is available from our Beamsville showroom or our warehouse terminal, stock dependent.
Is Incinolet approved in my area?
Although CSA approved, requirements vary by province and municipality. Treat it as an electrical appliance install and check with your local Authority Having Jurisdiction and a licensed electrician. diction and a licensed electrician.
Shipping and delivery
Shipping and delivery
Every Incinolet toilet includes free shipping anywhere in Canada except Yukon, Northwest Territories, and Nunavut, for a flat shipping fee of $250.00.
Delivery Times
- 2–5 business days
- 2–7 business days
Parts & Accessories
Replacement parts and bowl liners ship via UPS and are subject to standard shipping fees.
Remote or Limited Addresses
If your shipping address is not accessible, please arrange delivery to the nearest post office, courier pickup point, or freight terminal.
Please note: we cannot ship to PO Boxes.
Purchase Orders
Purchase orders are accepted. Include your PO number in the order notes when checking out, and a PDF invoice will be provided after purchase.
Additional Information
Shipments should be inspected on arrival. Please notify us within 48 hours of any damage.
For freight deliveries, carriers may contact you to arrange a delivery time.
Weather and regional conditions can extend transit times, we recommend ordering early if you have a deadline.
Couldn't load pickup availability
Restore reliable heater control and consistent performance with this Omron control relay. The relay switches power to the heater under the timer and controller’s commands, helping the unit run each cycle correctly. It is located in the control box beside the timer and controller; select the correct 120V or 240V variant for your unit.
Key Features
Controls the heater circuit based on the timer and temperature controller, supports proper incineration performance.
Two voltage variants available, choose 120V or 240V in options.
OEM Omron relay, listed on the Incinolet parts catalogue.
Quick service steps, relay is held by spring clips with six lead wires for a straightforward swap.
Compatibility
Fits Incinolet units with 120V or 240V electrical configurations; verify your unit voltage before ordering.
Location: control box, beside timer and controller.
Incinolet recommends including your serial number with parts orders for confirmation.
What’s Included
1 × Omron Relay, variant selected at checkout.
Installation & Care (Quick Tips)
Unplug the unit and remove the top.
Label and remove the six lead wires, hold back the spring clips, remove the relay, then install the replacement and rewire.
Reassemble and test a cycle.
Specs
Voltage options: 120V or 240V.
Variant SKUs: REL008/REL007 (120V); REL008/REL008 (240V).
Approx. weight: 0.1875 lb; dimensions: 2 × 2 × 2 in.
FAQs
What does this relay do?
It acts as an electrically controlled switch, allowing the controller to power the heater during a timed cycle.
How do I choose the correct variant?
Match your unit’s voltage to 120V or 240V and select the corresponding option when adding to cart.
Where is the relay located?
Inside the control box, beside the timer and controller.
Share
